3rd Generation Hydraulic Round Tube Bender, 1.625 Inch Die

In general, customers have had a positive experience with this bender. It has been praised for its durability, ease of use, and ability to accurately bend the desired angles. The quality materials and Construction of the bender have been highlighted, with customers noting that it is worth the slightly higher cost compared to competitors. One common issue mentioned is the difficulty in measuring and predicting bend angles, but customers have found ways around this by leaving longer tails and cutting to fit for more precise work. However, some customers have mentioned that they have become better at judging the bends with more practice. There have been a few minor issues reported, such as the safety cable breaking during installation, but these have not been major concerns and have been easily resolved. Another complaint is the limited availability of smaller radius dies for certain tube sizes. One reviewer experienced cracks and bowing in the die after making a relatively low number of bends, which was unexpected and disappointing. Another customer had difficulty bending thin wall tubing due to the distance between the point of bending and the follower. They attempted to contact Speedway about getting another roller and pin but did not receive a response. Overall, this bender is recommended for use with 1-3/4 x 0.12 DOM tube, as it Consistently produces clean bends. However, it may not be suitable for bending thin wall tubing. It is advised to have a digital angle finder for accurate measurements. Despite some minor issues, this bender is Considered a good investment that will last for many years.